Test for Determining Flammability of SpillFix Universal Organic Absorbent

(Based on the Burning Rate Test as per Clause 33.2.1.4.3.2 in the UN recommendations)

line2

 

Test: On pic.1, as per the test requirements, is a 200 mm strip (20mm wide by 10 mm high) of the SpillFix Organic. It should be noted whether combustion propagates along 200 mm of the strip within the 2 minutes test period.

line2

Pic 2. - A hot flame (min. temperature 1000C) from a gas burner was applied for 2 minutes. On pic 3. it can be seen that the 200 mm strip of the product didn't burn within the 2 minute test period. During the test the product was smouldering only at the place exposed to the flame.

line2

Conclusion: The above shows that SpillFix Organic should not be classified as a flammable solid. SpillFix Organic can be classified as Not Readily Combustible Solid of Division 4.1.

line2

Flammability Comparison

Test after absorption of oil spill (oil used: AWS – 68)

Test: The same Burning Test was repeated, this time comparing two products: SpillFix Organic and Diatomite. After absorbing oil AWS 68, a hot flame from a gas burner was applied for 2 minutes. The final result can be seen above. The product Diatomite caught fire, see pic B. This is because Diatomite has less absorbing capacity than SpillFix Organic and more of the oil was released when exposed to the hot flame. On the other side, SpillFix Organic having a greater absorbing capacity didn't release the absorbed oil when exposed to the hot flame and the product didn't catch fire, it was only smouldering – see pic A.

Conclusion: The above shows that SpillFix Organic has a greater absorbing capacity and is holding the absorbed oil better. However the two products should be used with caution when absorbing flammable spills.

Pic A. SpillFix Organic after the test | Pic B. Diatomite clay after the

Copyright © 2010 SpillFix Ltd. All rights reserved.
Design: de Tonssk & Lane New York
Privacy Statement Contact webmaster about any difficulties with this site